The Terminator is an automatic abatement system - PIG used to contain
contamination, on detection of pollution. It is inexpensive to purchase,
simple to install and reliable in operation. It may also be used
as a temporary seal to plug a pipe during routine maintenance.
The system utilises a special bladder manufactured and patented
by envirovalve™, which is pre-installed within a discharge
pipe. The bladder automatically inflates using compressed air when
water pollution is detected, allowing containment and remedial action
to be taken. Alternatively, the drainage system can be designed
to divert the pollution over a weir, into a holding tank for subsequent
treatment. The Terminator is therefore an ideal low cost, self-contained
solution, to arrest flow wherever there is a risk of contamination
affecting local watercourses. It’s simplicity allows for simple
installation avoiding expensive civil engineering costs.
It may be automatically triggered from any on-line monitor generating
a volt-free alarm output. Typical water quality parameters would
be pH, Turbidity, or Total Organic Carbon - TOC.
The surface mounted enclosure provides local indication when the
bladder has been inflated. Additional alarms also indicated when
there is insufficient pressure available to maintain or inflate
the device. Push button control is also provided to manually inflate
and deflate the bladder. It is recommended that the system be manually
activated to ensure it performs satisfactorily, at least on a weekly
interval.
|
|
| External air at 15psi required. Latched alarm maintains inflated
bladder |
Terminator-EI |
| External air at 15psi required. Released alarm deflates bladder
after event |
Terminator-ER |
| Integral compressor provides air supply. Latched alarm maintains
inflated bladder |
Terminator-IL |
| Integral compressor provides air supply. Released alarm deflates
bladder |
Terminator-IR |
| Connections |
6mm air in fitting (model E), 10mm air out
QM plugs for power supply & signals with 1.0m leads |
| Bladder Sizes |
150 to 600mm dia |
| Pressure Relief |
Internal pressure relief valve and regulator set to 12 psi |
| Operating Temp |
40°C to 100°C |
| Enclosure |
Solid GRP |
| Dimensions |
310(w) x 365(h) x 220(d) mm |
| Power Supply |
110 / 230VAC / 60 VA |
|